Pazon - Ignitions with a 7 1/2 year warranty
Pazon Ignitions Limited  >>  Products  >>  Accessories  >>  Voltage Regulators  >>  Alternator Rectifier/Regulators  >>  REGULATOR/RECTIFIER+CAPACITOR SINGLE-PHASE 12V ~ BATTERY ELIMINATOR

REGULATOR/RECTIFIER+CAPACITOR SINGLE-PHASE 12V ~ BATTERY ELIMINATOR


Details

Price: NZ$149.00

Plus G.S.T. (New Zealand only)


Currency Converter


Free Worldwide Shipping to most destinations for orders over NZ$250 (excl. GST)

Options

Quantity Sold Out

 

Rectifier/regulator for use with any single-phase two wire permanent magnet alternator, up to 200 watts, including Lucas RM21 AND RM23.

For powering lights and battery charging.
May be run without a battery, but note that this is not recommended for big singles (e.g. B44, B50), as starting the engine may not be possible when relying on alternator power only.

Simplify your wiring: replaces rectifier and zener diode on British bikes (single/twins and triples).

Also suits these Honda models: CR250 (02 on), XR350 (83-85), XR400R, XR600R, (88-90) XR650R

Can be used to convert 6 volt 3-wire alternators to 12 volt charging (see link to data sheet below).

Regulated output: 14.2 volts

Dimensions: 62mm x 31mm x 47mm deep

Not suitable for three-phase alternators (e.g. RM24).

One year warranty.

SPECIFICATIONS:

Regulated output voltage: 14.2 Volts

Charging voltage:  Dependent upon battery voltage and cable length to battery


Maximum power:    200 Watts in airflow (approx. 14 Amps @ 14.2V)

Wire lengths:  150mm from edge of casing (approx.)

Mounting: via single mounting hole, using M6x20mm cap head screw, washers and locknut (supplied)

Size: 62mm x 31mm x 47mm deep (approx.)

Total weight (INC. WIRES): 118gms. (approx.)

FITTING INSTRUCTIONS:

Locate the unit close to the battery, if possible.  Do not fit into a very confined space. Allow some air space around the unit for cooling, ideally in the airflow for high load systems.
Mount to the frame with M6 bolt, nut and washers (supplied). The case does not have to be earthed, therefore it can be rubber mounted or mounted onto a surface that is not grounded.

WIRING FUNCTIONS:

WARNING: IF USING WITH A BATTERY, DO NOT CONNECT TO THE BATTERY THE WRONG WAY AROUND


YELLOW & PINK WIRES: ALTERNATOR/GENERATOR INPUT

GREEN WIRE: 0 Volt (NEGATIVE) OUTPUT

BLACK WIRE: 12 Volt (POSITIVE) OUTPUT

For example wiring diagrams, see datasheet (under Additional Links tab).

Your name: *
Your e-mail: *
Recipient's e-mail: *

 Send to friend 
  Product rating
Product rating

Voting

 


 

Copyright © 2005-2024 Pazon Ignitions Limited  

Home | Company | Products | Privacy Policy | Contact Us