Pazon Ignitions Limited
>> Products
>> Accessories
>> Voltage Regulators
>> Alternator Rectifier/Regulators
>> REGULATOR/RECTIFIER SINGLE-PHASE 6V
REGULATOR/RECTIFIER SINGLE-PHASE 6V
Rectifier/regulator for use with two/three wire permanent magnet
alternators, e.g. Lucas RM19.
Prevent overcharging from damaging your electronic ignition, blowing bulbs or boiling the battery.
Replaces rectifier on British bikes.
Regulated output: 7.5 volts
Dimensions: 80mm x 80mm x 30mm deep
Not suitable for three-phase alternators (e.g. RM24).
One year warranty.
SPECIFICATIONS:
Regulated output voltage: 7.5 Volts
Charging voltage: Dependent upon battery voltage and cable length to battery
Maximum power: 200 Watts in airflow
Wire lengths: 270mm from edge of casing
Mounting slots: 62mm between centres
Slot width: tapered 6.8mm (top) to 8.6mm (bottom)
CASE SIZE: 80mm x 80mm x 30mm deep
TOTAL WEIGHT (INC. WIRES): 270gms. (approx.)
FITTING INSTRUCTIONS:
Locate the unit close to the battery, if possible. Do not fit into a very confined space. Allow some air space around the unit for cooling, ideally in the airflow for high load systems.
Mount to the frame with two fixing bolts, nuts and washers. The case does not have to be earthed, therefore it can be rubber mounted or mounted onto a surface that is not grounded.
WIRING FUNCTIONS:
WARNING: DO NOT CONNECT THE BATTERY THE WRONG WAY AROUND
YELLOW WIRES: ALTERNATOR INPUT
GREEN/BLACK WIRE: NEGATIVE OUTPUT
RED WIRE: POSITIVE OUTPUT
Regulated output voltage: 7.5 Volts
Charging voltage: Dependent upon battery voltage and cable length to battery
Maximum power: 200 Watts in airflow
Wire lengths: 270mm from edge of casing
Mounting slots: 62mm between centres
Slot width: tapered 6.8mm (top) to 8.6mm (bottom)
CASE SIZE: 80mm x 80mm x 30mm deep
TOTAL WEIGHT (INC. WIRES): 270gms. (approx.)
FITTING INSTRUCTIONS:
Locate the unit close to the battery, if possible. Do not fit into a very confined space. Allow some air space around the unit for cooling, ideally in the airflow for high load systems.
Mount to the frame with two fixing bolts, nuts and washers. The case does not have to be earthed, therefore it can be rubber mounted or mounted onto a surface that is not grounded.
WIRING FUNCTIONS:
WARNING: DO NOT CONNECT THE BATTERY THE WRONG WAY AROUND
YELLOW WIRES: ALTERNATOR INPUT
GREEN/BLACK WIRE: NEGATIVE OUTPUT
RED WIRE: POSITIVE OUTPUT
Recommended Products
| Related products | |||||
|
| Product rating | |||
Copyright © 2005-2008 Pazon Ignitions Limited
